The pellet ice machine, also known as the square ice machine, has crystal clear ice cubes, is beautiful and elegant, fully automatic control, and users only need to connect the water and electricity to use it. It is energy-saving, clean and hygienic. Granular ice has good anti melting properties and is suitable for beverage preparation, decoration, food ice storage and preservation, etc

1. Ice making operation process

Before starting up, it is necessary to check whether the automatic water supply device is working properly and whether the water tank storage capacity is reasonable (the water level has been adjusted to the correct level when the machine leaves the factory, and the user does not need to adjust it).

⑵ Plug in the power and the ice maker starts working. First, the water pump starts running (the water pump has a short air discharge process). After about 2 minutes, the compressor starts and the machine enters the ice making state.

When the thickness of the ice cube reaches the set thickness, the ice sheet probe starts to activate, the defrost solenoid valve starts to work, the water pump stops working, and hot air enters the evaporator. After about 1 minute, the ice cube falls down. When the ice falls, flip the ice stopper and turn on the magnetic spring switch. When the magnetic spring switch is closed again, the machine enters another ice making process.

The compressor does not stop during the entire ice making and de icing process.

When the ice storage bin is full of ice and the magnetic spring switch cannot be automatically closed, the machine will automatically stop working. When enough ice cubes are taken, the magnetic spring switch will close again, and after a delay of 3 minutes, the machine will start again and enter the ice making process.

2. Adjustment of Ice Bridge Thickness

The thickness of the ice bridge should be about 3mm, and the gap between the probe and the evaporator should be about 1.5mm thicker than the actual ice bridge thickness. Rotate the adjusting screw clockwise to increase the ice bridge thickness (rotate the screw 1/3 turn to change the ice bridge thickness by 1.5mm).

⑵ Check the wiring and connection bracket of the ice tray probe, ensuring free rotation to return to the correct position after each ice making process.